-
I bulloni forniti hanno la lunghezza corretta per l'installazione di un verricello WINCHMAX da 13500 libbre su una piastra da 5-7 mm. Spessori diversi potrebbero richiedere bulloni di lunghezze diverse. I criteri richiesti sono che i bulloni siano almeno di grado 8.8 ad alta resistenza, la lunghezza della filettatura deve essere sufficientemente lunga da innestare completamente il dado quadrato ma non deve sporgere al punto che il bullone entri in contatto con la parte superiore dell'alloggiamento del dado nel telaio del verricello.
Leggere la guida all'uso dei bulloni di montaggio nella scheda "specifiche".
Il set di bulloni di montaggio del verricello 13500 è composto da:
4 bulloni esagonali M10x30 grado 8.8
4 dadi quadrati M10 (15,8 mm x 15,8 mm x 8,3 mm)
4 rondelle piatte M10 (spessore 2,0 mm)
4 rondelle elastiche M10 (spessore 2,8 mm)
2 bulloni esagonali M12x25 grado 8.8
2 dadi esagonali M12 grado 8.8
2 rondelle piatte M12 (2,0 mm spessore)
2 rondelle elastiche M12 (spessore 3,3 mm)
-
- Install a suitable mounting bumper or mounting plate in the required position. The winch must be mounted with the direction of pull perpendicular to the mounting bolt fixings. The plate should be fabricated from minimum 6mm steel.
- Attach fairlead (roller type for wire rope or aluminium hawse for synthetic rope) to the mounting plate using two hex nuts (9) & bolts (1) with flat (7) and spring (8) washers.
- Insert the four square nuts (2) into the pockets at the base of the winch frame.
- Thread the four high tensile bolts (5) with flat (3) and spring (4) washers up through the mounting plate and into the square nuts in the winch. Tighten the mounting bolts to a torque setting of 60Nm.
- The supplied bolts are the correct length for installation on a 5-7mm plate. Other thickness’s may require bolts of a different length. The required criteria are that the bolts are at least 8.8 grade high tensile, the thread length should be sufficiently long to fully engage the square nut but must not protrude to the extent that the bolt contacts the top of the nut housing in the winch frame.
- The mounting bolt must only be used with the correct square nut designed to seat into the nut pockets formed in each corner of the motor and gearbox base. Never use standard hexagonal type nuts.
- When selecting a bolt length the thread must be long enough to pass through the mounting material and fully fill the thread of the square nut without contacting the top of the mounting bolt pocket.
- The supplied flat washer and split lock washer should always be used.
- The minimum mounting bolt thread length = the thickness of the mounting material plus 24mm The maximum mounting bolt thread length = the thickness of the mounting material plus 29.5mm
- If you need to increase the clearance in the nut pocket, addition washers can be used but we do not recommend an increment of more than 4mm.
- Failing to correctly mount your winch could result in a catastrophic structural failure to the winch and serious consequential damage/injury.
-